Click here

VALVE BODY ASSEMBLY REMOVAL

Click here
Click here Click here
  1. Click here

    REMOVE NO. 2 ENGINE UNDER COVER


    1. A015A78

      Remove the 2 bolts and No. 2 engine under cover.

  2. Click here

    REMOVE OIL PAN PROTECTOR ASSEMBLY


    1. Remove the 4 bolts and oil pan protector.

  3. Click here

    DRAIN AUTOMATIC TRANSMISSION FLUID


    1. Remove the drain plug and gasket, and drain the ATF.

    2. Install a new gasket and the drain plug.

      20 N*m 204 kgf*cm 15 ft.*lbf
  4. Click here

    REMOVE AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY


    1. A0159YDE01

      Remove the 12 bolts, oil pan and gasket from the transmission.

      Note:

      Some fluid will remain in the oil pan. Remove all the bolts, and carefully remove the oil pan assembly.

    2. A0158FPE01

      Examine the particles in the pan.


      1. Remove the 4 magnets and use them to collect steel particles. Carefully inspect the foreign matter and particles in the pan and on the magnets to anticipate the type of wear you will find in the transmission.

        Steel (magnetic): bearing, gear and clutch plate wear

        Brass (non-magnetic): bush wear

  5. Click here

    REMOVE VALVE BODY OIL STRAINER ASSEMBLY


    1. A015D3H

      Remove the 4 bolts and oil strainer.

      Note:

      Be careful as some fluid may leak out of the oil strainer.

    2. Remove the O-ring from the oil strainer.

  6. Click here

    DISCONNECT TRANSMISSION WIRE


    1. Remove the 2 bolts and 2 temperature sensor clamps.

    2. Disconnect the 2 ATF temperature sensors.

    3. Disconnect the 9 connectors from the solenoid valves.

  7. Click here

    REMOVE TRANSMISSION VALVE BODY ASSEMBLY


    1. Remove the bolt, detent spring cover and detent spring.

    2. A0159YHE02

      Remove the 19 bolts and valve body.

    3. A015947E04

      Remove the check ball body and spring.

      Note:

      Do not drop the check ball body and spring.