TRANSMISSION WIRE INSTALLATION


  1. INSTALL TRANSMISSION WIRE


    1. Coat the O-ring of the transmission wire connector with ATF.

    2. A015A5Q

      Install the 2 transmission wires with the 2 bolts.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }
    3. A015663E02

      Connect the 2 transmission wire connectors.

      Tech Tips

      Push up the lever until the claw of the transmission wire connector makes a connection sound.

  2. CONNECT TRANSMISSION WIRE

    A0156UBE03
    Text in Illustration
    *a Orange
    *b Blue

    1. Connect the 9 connectors to the solenoid valves.

    2. Connect the 2 ATF temperature sensors with the 2 clamps and 2 bolts.

      Torque:
      for bolt A
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }
      for bolt B
      11 N*m  { 112 kgf*cm, 8 ft.*lbf }

      Tech Tips

      Each bolt length is indicated below.

      12 mm (0.472 in.) for bolt A

      36 mm (1.41 in.) for bolt B

  3. INSTALL VALVE BODY OIL STRAINER ASSEMBLY

    A015D3H

    1. Coat a new O-ring with ATF and install it to the oil strainer.

    2. Install the oil strainer with the 4 bolts.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

  4. INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY

    A0159I3E04
    Text in Illustration
    *1 Magnet

    1. Install the 4 transmission oil cleaner magnets to the oil pan.

    2. A0159YDE01
      Text in Illustration
      *1 Sleeve
      *2 Protrusion
      *a Correct
      *b Incorrect

      Install a new gasket and the oil pan with the 12 bolts.

      Torque:
      7.4 N*m  { 75 kgf*cm, 65 in.*lbf }

      Note

      A015DSME02

      • Make sure that there is no oil or foreign matter on the gasket seal surface and oil pan contact surface.

      • Install the gasket so that there is no slack in the gasket, and make sure the entire circumference of the seal surface is level.

      • Make sure that the 9 gasket drop prevention protrusions are set on the oil pan.

      • When tightening the bolts of the oil pan, make sure that the gasket is not pinched between the gasket tightening area sleeve and the transmission seal surface.

  5. ADD AUTOMATIC TRANSMISSION FLUID

    Click here

  6. INSTALL OIL PAN PROTECTOR ASSEMBLY

    A015AER

    1. Install the oil pan protector with the 4 bolts.

      Torque:
      63 N*m  { 642 kgf*cm, 46 ft.*lbf }

  7. INSTALL NO. 2 ENGINE UNDER COVER


    1. Install the No. 2 engine under cover with the 2 bolts.

      Torque:
      29 N*m  { 296 kgf*cm, 21 ft.*lbf }