Click here

AUTOMATIC TRANSMISSION SYSTEM (for 1UR-FE), Diagnostic DTC:P2772

Click here
Click here Click here
DTC Code DTC Name
P2772 Four Wheel Drive (4WD) Low Switch Circuit Range / Performance
Click here

DESCRIPTION

The ECM detects the signal from the transfer L4 position switch.

This DTC indicates that the transfer L4 position switch remains on.

DTC Code DTC Detection Condition Trouble Area
P2772

The transfer L4 position switch remains on while the vehicle is running under the following conditions for 1.8 sec. or more (1 trip detection logic).

(a) The output shaft speed is between 1000 and 3000 rpm.

(b) The transfer position switch is in H4.

  • Short in transfer L4 position switch circuit

  • Four wheel drive control ECU

  • ECM
Click here

MONITOR DESCRIPTION

The ECM monitors the transfer-case L4 position switch to determine when the transfer-case L4 gears are engaged. If the L4 switch indicates that the transfer-case L4 gears remain engaged under the following conditions, the ECM will conclude that there is a malfunction of the L4 position switch, illuminate the MIL and store the DTC:


Click here

WIRING DIAGRAM

Click here

INSPECTION PROCEDURE

Click here

PROCEDURE


  1. Click here

    CHECK HARNESS AND CONNECTOR (FOUR WHEEL DRIVE CONTROL ECU - BODY GROUND)


    1. A015AKJE19

      Disconnect the four wheel drive control ECU connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      A27-21 (L4) - Body ground Always 10 kΩ or higher
      Table 1. Text in Illustration
      *a

      Front view of wire harness connector

      (to Four Wheel Drive Control ECU)

  2. Click here

    CHECK HARNESS AND CONNECTOR (FOUR WHEEL DRIVE CONTROL ECU - ECM)


    1. A015AUVE06

      Disconnect the ECM connector.

    2. Disconnect the A27 four wheel drive control ECU connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Table 2. for LHD
      Tester Connection Condition Specified Condition
      A38-21 (L4) - Body ground Always 10 kΩ or higher
      Table 3. for RHD
      Tester Connection Condition Specified Condition
      A52-21 (L4) - Body ground Always 10 kΩ or higher
      Table 4. Text in Illustration
      *1 for LHD
      *2 for RHD
      *a

      Front view of wire harness connector

      (to ECM)

  3. Click here

    REPLACE ECMClick here

  4. Click here

    GO TO TRANSFER SYSTEM INSPECTIONClick here

  5. Click here

    REPAIR OR REPLACE HARNESS OR CONNECTOR