VALVE BODY ASSEMBLY REMOVAL


  1. DRAIN AUTOMATIC TRANSMISSION FLUID


    1. Remove the drain plug and gasket, and drain the ATF.

    2. Install a new gasket and the drain plug.

      Torque:
      20 N*m  { 204 kgf*cm, 15 ft.*lbf }

  2. REMOVE AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY


    1. A01599KE01

      Remove the 20 bolts, oil pan and gasket from the transmission.

      Note

      Some fluid will remain in the oil pan. Remove all the pan bolts, and carefully remove the oil pan assembly.

    2. A0158FPE01

      Examine the particles in the pan.


      1. Remove the 4 magnets and use them to collect steel particles. Carefully inspect the foreign matter and particles in the pan and on the magnets to anticipate the type of wear you will find in the transmission.

        Steel (magnetic): bearing, gear and clutch plate wear

        Brass (non-magnetic): bush wear

  3. REMOVE VALVE BODY OIL STRAINER ASSEMBLY


    1. A015ABBE01

      Remove the 4 bolts and oil strainer.

      Note

      Be careful as some fluid may leak out of the oil strainer.

    2. Remove the O-ring from the oil strainer.

  4. DISCONNECT TRANSMISSION WIRE

    A0157RU

    1. Remove the 2 bolts and 2 temperature sensor clamps.

    2. Disconnect the ATF temperature sensors.

    3. Disconnect the 7 connectors from the solenoid valves.

  5. REMOVE TRANSMISSION VALVE BODY ASSEMBLY


    1. Remove the bolt, detent spring cover and detent spring.

    2. A015CVFE02

      Remove the 19 bolts and valve body.

    3. A015947E04

      Remove the check ball body and spring.

      Note

      Do not drop the check ball body and spring.