Click here

TRANSMISSION WIRE INSTALLATION

Click here
Click here Click here
  1. Click here

    INSTALL TRANSMISSION WIRE


    1. Coat the O-ring of the transmission wire connector with ATF.

    2. A0156N4

      Install the transmission wire with the bolt.

      5.4 N*m 55 kgf*cm 48 in.*lbf
    3. A015E5J

      Connect the transmission wire connector.

      Tip:

      Push up the lever until the claw of the transmission wire connector makes a connection sound.

  2. Click here

    CONNECT TRANSMISSION WIRE


    1. A0157RUE02

      Connect the 7 connectors to the solenoid valves.

    2. Connect the 2 ATF temperature sensors with the 2 clamps and 2 bolts.

      for bolt A
      10 N*m 102 kgf*cm 7 ft.*lbf
      for bolt B
      11 N*m 112 kgf*cm 8 ft.*lbf
      Tip:

      Each bolt length is indicated below.

      12 mm (0.472 in.) for bolt A

      36 mm (1.42 in.) for bolt B

  3. Click here

    INSTALL VALVE BODY OIL STRAINER ASSEMBLY


    1. Coat a new O-ring with ATF and install it to the oil strainer.

    2. Install the oil strainer with the 4 bolts.

      10 N*m 102 kgf*cm 7 ft.*lbf
  4. Click here

    INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY

    Note:

    Remove the gasket and be careful not to spill oil on the contacting surfaces of the transmission case and oil pan.


    1. Install a new gasket and the oil pan with the 20 bolts.

      4.4 N*m 45 kgf*cm 39 in.*lbf
  5. Click here

    ADD AUTOMATIC TRANSMISSION FLUID


    1. Add automatic transmission fluid (Click here).