Click here

TRANSMISSION WIRE REMOVAL

Click here
Click here Click here
  1. Click here

    DRAIN AUTOMATIC TRANSMISSION FLUID


    1. Remove the drain plug and gasket, and drain the ATF.

    2. Install a new gasket and the drain plug.

      20 N*m 204 kgf*cm 15 ft.*lbf
  2. Click here

    REMOVE AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY


    1. A01599KE01

      Remove the 20 bolts, oil pan and gasket from the transmission.

      Note:

      Some fluid will remain in the oil pan. Remove all the pan bolts, and carefully remove the oil pan assembly.

    2. A0158FPE01

      Examine the particles in the pan.


      1. Remove the 4 magnets and use them to collect steel particles. Carefully inspect the foreign matter and particles in the pan and on the magnets to anticipate the type of wear you will find in the transmission.

        Steel (magnetic): bearing, gear and clutch plate wear

        Brass (non-magnetic): bush wear

  3. Click here

    REMOVE VALVE BODY OIL STRAINER ASSEMBLY


    1. A015ABBE01

      Remove the 4 bolts and oil strainer.

      Note:

      Be careful as some fluid may leak out of the oil strainer.

    2. Remove the O-ring from the oil strainer.

  4. Click here

    DISCONNECT TRANSMISSION WIRE


    1. Remove the 2 bolts and 2 temperature sensor clamps.

    2. Disconnect the ATF temperature sensors.

    3. Disconnect the 7 connectors from the solenoid valves.

  5. Click here

    REMOVE TRANSMISSION WIRE


    1. Disconnect the wire connector.


      1. Detach the claw, press down the lever, and then disconnect the transmission wire connector.

    2. A0156N4

      Remove the bolt and pull out the transmission wire.