Click here

CRUISE CONTROL MAIN SWITCH INSTALLATION

Click here
Click here Click here
Tip:

  • Use the same procedures for LHD and RHD vehicles.

  • The procedures listed below are for LHD vehicles.

Click here
  1. Click here

    INSTALL CRUISE CONTROL MAIN SWITCH


    1. A015C2W

      Install the switch.

    2. A0157YS

      Install the 2 screws.

    3. A015A32

      Connect the connector and clamp.

  2. Click here

    INSTALL STEERING PAD


    1. A0155SD

      Support the steering pad with one hand.

    2. Connect the 2 connectors to the steering pad.

      Note:

      When handling the airbag connector, take care not to damage the airbag wire harness.

    3. Connect the horn connector.

    4. Confirm that the circumference groove of the "TORX" screw fits in the screw case, and place the steering pad onto the steering wheel.

    5. Using a T30 "TORX" socket wrench, tighten the 2 screws.

      8.8 N*m 90 kgf*cm 78 in.*lbf
  3. Click here

    INSTALL LOWER NO. 3 STEERING WHEEL COVER


    1. A015BV6

      Attach the 2 claws to install the cover.

  4. Click here

    INSTALL LOWER NO. 2 STEERING WHEEL COVER


    1. A0159MPE01

      Attach the 2 claws to install the cover.

  5. Click here

    CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  6. Click here

    CHECK SRS WARNING LIGHT


    1. Check the SRS warning light (Click here).