Click here

CRUISE CONTROL MAIN SWITCH REMOVAL

Click here
Click here Click here
Tip:

  • Use the same procedures for LHD and RHD vehicles.

  • The procedures listed below are for LHD vehicles.

Click here
  1. Click here

    PRECAUTION

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).

  2. Click here

    DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  3. Click here

    REMOVE LOWER NO. 3 STEERING WHEEL COVER


    1. A015BV6

      Detach the 2 claws and remove the steering wheel cover.

  4. Click here

    REMOVE LOWER NO. 2 STEERING WHEEL COVER


    1. A0159MPE01

      Detach the 2 claws and remove the steering wheel cover.

  5. Click here

    REMOVE STEERING PAD


    1. A0158E8E01

      Using a T30 "TORX" socket wrench, loosen the 2 screws until the groove along the screw circumference catches on the screw case.

    2. A0155SD

      Pull out the steering pad from the steering wheel, as shown in the illustration. Then support the steering pad with one hand.

      Note:

      When removing the steering pad, do not pull the airbag wire harness.

    3. Disconnect the horn connector.

    4. Disconnect the 2 connectors and remove the steering pad.

      Note:

      When handling the airbag connector, take care not to damage the airbag wire harness.

  6. Click here

    REMOVE CRUISE CONTROL MAIN SWITCH


    1. A015A32

      Disconnect the connector and clamp.

    2. A0157YS

      Remove the 2 screws.

    3. A0155O5

      Remove the switch.