DYNAMIC RADAR CRUISE CONTROL SYSTEM, Diagnostic DTC:P1575

DESCRIPTION

INSPECTION PROCEDURE

PROCEDURE

1. Click here

   PERFORM ACTIVE TEST USING INTELLIGENT TESTER (BUZZER)

   
   

   1. Using the intelligent tester, perform the Active Test (Click here).

      Table 1. ABS/VSC/TRAC

      Tester Display	Test Part	Control Range	Diagnostic Note
      Buzzer	Skid control buzzer sounds	OFF or ON	-

      OK
      Skid control buzzer sounds.

   
   
   • OKClick here
   • NGClick here
2. Click here

   CHECK DTC (DYNAMIC RADAR CRUISE CONTROL SYSTEM)

   
   

   1. Using the intelligent tester, enter the following menus: Powertrain / Radar Cruise / Trouble Code.

   2. Clear the DTCs (Click here).

   3. Perform the following to make sure the DTC detection conditions are met.

      Tip:

      If the detection conditions are not met, the system cannot detect the malfunction.

      
      

      1. Drive the vehicle at a speed of 50 km/h (30 mph) or more.

      2. Turn the cruise control main switch on to set the vehicle-to-vehicle distance control mode to the standby state.

   4. Check for DTCs (Click here).

      OK
      DTC P1575 is not output.

      Table 2. Result

      Result	Proceed to
      OK	A
      NG (for 1UR-FE)	B
      NG (for 3UR-FE)	C

   
   
   • AClick here
   • BClick here
   • CClick here
3. Click here

   USE SIMULATION METHOD TO CHECKClick here

4. Click here

   GO TO VEHICLE STABILITY CONTROL SYSTEM (Skid Control Buzzer Circuit)Click here

5. Click here

   REPLACE ECMClick here

6. Click here

   REPLACE ECMClick here