Click here

DYNAMIC RADAR CRUISE CONTROL SYSTEM, Diagnostic DTC:P0575

Click here
Click here Click here
DTC Code DTC Name
P0575 Cruise Control Input Circuit
Click here

DESCRIPTION

This DTC indicates internal abnormalities of the ECM.

DTC Code DTC Detection Condition Trouble Area
P0575

When either of the following conditions is met:


  • STP signals input to the ECM supervisory CPU and control ECU are different for 0.15 seconds or more.

  • 0.4 seconds have passed after the cruise cancel input signal (STP input) is input to the ECM.

 ECM
Tip:

If DTC P0575 is stored while the dynamic radar cruise control is in operation, the master cylinder solenoid (skid control ECU) clears the stored vehicle speed in the ECM and cancels the dynamic radar cruise control operation. At the same time, the cruise control indicator light blinks to inform the driver of the malfunction. When this trouble code is stored, fail-safe remains on until the engine switch is turned off.

Click here

INSPECTION PROCEDURE

Click here

PROCEDURE


  1. Click here

    CHECK DTC (DYNAMIC RADAR CRUISE CONTROL SYSTEM)


    1. Using the intelligent tester, enter the following menus: Powertrain / Radar Cruise / Trouble Code.

    2. Clear the DTCs (Click here).

    3. Recheck for DTCs (Click here).

      OK
      DTC P0575 is not output.
      Table 1. Result
      Result Proceed to
      OK A
      NG (for 1UR-FE) B
      NG (for 3UR-FE) C

  2. Click here

    USE SIMULATION METHOD TO CHECKClick here

  3. Click here

    REPLACE ECMClick here

  4. Click here

    REPLACE ECMClick here