DYNAMIC RADAR CRUISE CONTROL SYSTEM, Diagnostic DTC:P0500

DTC Code DTC Name
P0500 Vehicle Speed Sensor Malfunction

DESCRIPTION

The speed sensor detects the wheel speed and sends the appropriate signals to the master cylinder solenoid (skid control ECU). The master cylinder solenoid (skid control ECU) converts these wheel speed signals into a 4-pulse signal and outputs it to the ECM via the combination meter. The ECM determines the vehicle speed based on the frequency of these pulse signals.

DTC Code DTC Detection Condition Trouble Area
P0500 The vehicle speed signal from the vehicle speed sensor is cut for 0.14 seconds. or more while cruise control is in operation.

  • Vehicle speed sensor signal circuit

  • Vehicle speed sensor

  • Combination meter

  • ECM

WIRING DIAGRAM

A015D18E04

INSPECTION PROCEDURE

This DTC code may be output under the SFI system at the same time. In that case, perform troubleshooting for the SFI system first.

PROCEDURE


  1. CHECK DTC (CRUISE CONTROL SYSTEM)


    1. Using the intelligent tester, enter the following menus: Powertrain / Radar Cruise / Trouble Code.

    2. Clear the DTCs Click here.

    3. Perform the following to make sure the DTC detection conditions are met.

      Tech Tips

      If the detection conditions are not met, the system cannot detect the malfunction.


      1. With the shift lever in D, drive the vehicle for more than 10 seconds when the engine coolant temperature is more than 20°C (68°F).

    4. Check for DTCs Click here.

      OK
      DTC P0500 is not output.
      Result
      Result Proceed to
      OK A
      NG (for 1UR-FE) B
      NG (for 3UR-FE) C

    B

    GO TO SFI SYSTEM Click here

    C

    GO TO SFI SYSTEM Click here

    A

    USE SIMULATION METHOD TO CHECK Click here