Click here

GLOW PLUG REMOVAL

Click here
Click here Click here
Note:

  • When replacing an injector (including interchanging injectors between cylinders) or common rail, replace the corresponding injection pipes with new ones.

  • w/DPF

    When fuel lines are disconnected, air may enter the fuel lines, leading to engine starting trouble. Therefore, perform forced regeneration and bleed the air from the fuel lines.

Click here
  1. Click here

    PRECAUTION

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).

  2. Click here

    DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  3. Click here

    REMOVE INTERCOOLER ASSEMBLY (w/ Intercooler)

    (Click here)

  4. Click here

    REMOVE INJECTION PIPES

    (Click here)

  5. Click here

    REMOVE NO. 1 GLOW PLUG CONNECTOR


    1. Remove the 2 screw grommets and 2 nuts, and disconnect the 2 wire harnesses.

    2. A015DN4E01

      Remove the 8 screw grommets, 8 nuts and 2 glow plug connectors.

      Table 1. Text in Illustration
      *a RH
      *b LH
  6. Click here

    REMOVE GLOW PLUG ASSEMBLY


    1. A01580TE01

      Using a 10 mm deep socket wrench, remove the 8 glow plugs.

      Table 2. Text in Illustration
      *a RH
      *b LH
      Tip:

      Before removing the glow plugs, thoroughly clean off all dirt, sand, etc.