ENGINE OIL COOLER REMOVAL


  1. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH


    1. A015DL0

      Remove the 3 bolts and screw.

    2. Loosen the clip and remove the front fender splash shield LH.

  2. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH


    1. Remove the 3 bolts and 2 screws.

    2. Loosen the clip and remove the front fender splash shield RH.

  3. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY


    1. A0157XJ

      Remove the 10 bolts and No. 1 engine under cover.

  4. DRAIN ENGINE COOLANT

    CAUTION:

    Do not remove the radiator reservoir cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

    Tech Tips

    Collect the coolant in a container and dispose of it according to the regulations in your area.


    1. Loosen the radiator drain cock plug.

    2. Remove the radiator reservoir cap to drain the coolant in the radiator.

    3. Loosen the oil filter bracket drain cock plug to drain the coolant in the engine.

      A015DKUE01

    4. Tighten the radiator drain cock plug by hand.

    5. A0158UW

      Tighten the oil filter bracket drain cock plug.

      Torque:
      13 N*m  { 133 kgf*cm, 10 ft.*lbf }

  5. DRAIN ENGINE OIL


    1. A0158YG

      Remove the 2 bolts and No. 2 engine under cover seal from the No. 2 engine under cover.

    2. Remove the oil filler cap.

    3. Remove the oil pan drain plug and gasket, and then drain the engine oil into a container.

    4. Install a new gasket and the oil pan drain plug.

      Torque:
      38 N*m  { 387 kgf*cm, 28 ft.*lbf }

  6. REMOVE OIL COOLER ASSEMBLY


    1. A0156HU

      Remove the 2 bolts, 2 nuts and oil cooler.

    2. A015DHH

      Remove the 2 O-rings and oil cooler gasket.