OIL LEVEL SENSOR REMOVAL


  1. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH


    1. A01588F

      Remove the 3 bolts and screw.

    2. Turn the clip indicated by the arrow in the illustration to remove the front fender splash shield sub-assembly LH.

  2. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH


    1. A0159SG

      Remove the 3 bolts and 2 screws.

    2. Turn the clip indicated by the arrow in the illustration to remove the front fender splash shield sub-assembly RH.

  3. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY


    1. A015CCZ

      Remove the 10 bolts and No. 1 engine under cover.

  4. REMOVE NO. 2 ENGINE UNDER COVER


    1. A015A78

      Remove the 2 bolts and No. 2 engine under cover.

  5. DRAIN ENGINE OIL


    1. Remove the oil filler cap.

    2. A0159J6

      Remove the 2 bolts and No. 2 engine under cover seal.

    3. Remove the oil pan drain plug and gasket, and drain the engine oil into a container.

    4. Install a new gasket and the oil pan drain plug.

      Torque:
      40 N*m  { 408 kgf*cm, 30 ft.*lbf }

  6. DISCONNECT OIL COOLER PIPE ASSEMBLY


    1. A015AGP

      Remove the 2 bolts and disconnect the oil cooler pipe.

  7. REMOVE ENGINE OIL LEVEL SENSOR


    1. Disconnect the oil level sensor connector.

    2. A015A0I

      Remove the 4 bolts and oil level sensor.

    3. A0159LQE01
      Text in Illustration
      *1 Cutting Position
      *2 Supply Part

      Cut off the gasket as shown in the illustration.

    4. Remove the gasket from the oil level sensor.

      Tech Tips

      After cutting away the parts of the gasket shown in the illustration, remove only the outer part of the gasket.