Click here

OIL LEVEL SENSOR REMOVAL

Click here
Click here Click here
  1. Click here

    REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH


    1. A01588F

      Remove the 3 bolts and screw.

    2. Turn the clip indicated by the arrow in the illustration to remove the front fender splash shield sub-assembly LH.

  2. Click here

    REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH


    1. A0159SG

      Remove the 3 bolts and 2 screws.

    2. Turn the clip indicated by the arrow in the illustration to remove the front fender splash shield sub-assembly RH.

  3. Click here

    REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY


    1. A0157XJ

      Remove the 10 bolts and No. 1 engine under cover sub-assembly.

  4. Click here

    REMOVE NO. 2 ENGINE UNDER COVER


    1. A015A78

      Remove the 2 bolts and No. 2 engine under cover.

  5. Click here

    DRAIN ENGINE OIL


    1. Remove the oil filler cap.

    2. A0159J6

      Remove the 2 bolts and No. 2 engine under cover seal.

    3. Remove the oil pan drain plug and gasket, and drain the engine oil into a container.

    4. Install a new gasket and the oil pan drain plug.

      40 N*m 408 kgf*cm 30 ft.*lbf

    5. Install the No. 2 engine under cover seal with the 2 bolts.

      10 N*m 102 kgf*cm 7 ft.*lbf
  6. Click here

    DISCONNECT OIL COOLER TUBE


    1. A0157D6

      Remove the 2 bolts and disconnect the oil cooler tube.

  7. Click here

    REMOVE ENGINE OIL LEVEL SENSOR


    1. Disconnect the oil level sensor connector.

    2. A015A0I

      Remove the 4 bolts and oil level sensor.

    3. A0159LQE01

      Cut away part of the gasket and remove the gasket from the engine oil level sensor.

      Table 1. Text in Illustration
      *1 Cutting Position
      *2 Supply Part
      Tip:

      Remove the only the outer part of the gasket.