OIL LEVEL SENSOR REMOVAL


  1. REMOVE FRONT WHEEL RH

  2. REMOVE FRONT FENDER APRON SEAL FRONT RH


    1. A015AN4

      Remove the 3 clips and front fender apron seal front RH.

  3. REMOVE FRONT FENDER APRON SEAL REAR RH


    1. A015D4I

      Remove the 4 clips and front fender apron seal rear RH.

  4. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH


    1. A01588F

      Remove the 3 bolts and screw.

    2. Turn the clip indicated by the arrow in the illustration to remove the front fender splash shield sub-assembly LH.

  5. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH


    1. A0159SG

      Remove the 3 bolts and 2 screws.

    2. Turn the clip indicated by the arrow in the illustration to remove the front fender splash shield sub-assembly RH.

  6. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY


    1. A0157XJ

      Remove the 10 bolts and No. 1 engine under cover.

  7. DRAIN ENGINE OIL


    1. A0158YG

      Remove the 2 bolts and No. 2 engine under cover seal from the No. 2 engine under cover.

    2. Remove the oil filler cap.

    3. Remove the oil pan drain plug and gasket, and then drain the engine oil into a container.

    4. Install a new gasket and the oil pan drain plug.

      Torque:
      38 N*m  { 387 kgf*cm, 28 ft.*lbf }

  8. REMOVE NO. 2 ENGINE UNDER COVER


    1. A015A78

      Remove the 2 bolts and No. 2 engine under cover.

  9. DISCONNECT OIL COOLER TUBE (for Automatic Transmission)


    1. A015C5H

      Remove the 3 bolts and disconnect the oil cooler tube from the engine.

  10. REMOVE ENGINE OIL LEVEL SENSOR


    1. A015CS5

      Disconnect the sensor connector.

    2. Remove the 4 bolts and sensor.

    3. Remove the gasket from the sensor.