TURBO MOTOR DRIVER INSTALLATION


  1. INSTALL TURBO MOTOR DRIVER


    1. A015AJKE01

      Insert the bracket tab into the slot labeled A and insert the 2 stud bolts into the bracket hole as shown in illustration.

    2. Install the 2 nuts and bolt.

      Torque:
      20 N*m  { 199 kgf*cm, 14 ft.*lbf }
    3. A0155ZK

      Connect the connector. Then move the lock lever as shown in the illustration to lock the connectors.

  2. INSTALL FRONT FENDER LINER RH


    1. Install the fender liner with the 5 clips.

    2. Using a T30 "TORX" socket, install the 3 screws.

    3. Connect the liner to the front bumper cover with the screw.

  3. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH


    1. Install the front fender splash shield RH with the clip, and then install the 3 bolts and 2 screws.

  4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.


    1. Connect the cables to the negative (-) main battery and sub-battery terminals.