Click here

SNORKEL AIR CLEANER INSTALLATION

Click here
Click here Click here
  1. Click here

    INSTALL INLET AIR CLEANER SEAL BRACKET SUB-ASSEMBLY


    1. A01573G

      Install the inlet air cleaner seal bracket with the 2 bolts.

      6.5 N*m 70 kgf*cm 58 in.*lbf
  2. Click here

    INSTALL NO. 2 INLET AIR CLEANER


    1. A0158FT

      Install the No. 2 inlet air cleaner with the 2 bolts.

      5.5 N*m 56 kgf*cm 49 in.*lbf
  3. Click here

    INSTALL AIR CLEANER ASSEMBLY


    1. Install the air cleaner case with the 3 bolts.

      5.0 N*m 51 kgf*cm 44 in.*lbf

    2. Attach the wire harness clamp to the air cleaner case.

    3. Connect the mass air flow meter connector and attach the wire harness clamp to the air cleaner cap.

  4. Click here

    INSTALL NO. 1 INLET AIR CLEANER


    1. A015CA0E01

      Attach the claw of the No. 1 inlet air cleaner to the No. 2 inlet air cleaner, and install the No. 1 inlet air cleaner with the 2 bolts.

      5.5 N*m 56 kgf*cm 49 in.*lbf
  5. Click here

    INSTALL FRONT FENDER LINER RH


    1. Install the fender liner with the 5 clips.

    2. Using a T30 "TORX" socket, install the 3 screws.

    3. Connect the liner to the front bumper cover with the screw.

  6. Click here

    INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH


    1. Install the front fender splash shield RH with the clip, and then install the 3 bolts and 2 screws.

  7. Click here

    INSTALL COOL AIR INTAKE PIPE RETAINER


    1. A015E5G

      Install the cool air intake pipe retainer with the 2 bolts.

  8. Click here

    INSTALL COOL AIR INTAKE DUCT


    1. A0156JA

      Install the cool air intake duct with the 2 bolts.

  9. Click here

    INSTALL AIR PRE-CLEANER ASSEMBLY


    1. A0157PD

      Temporarily install the No. 2 inlet air cleaner bracket to the inlet air cleaner seal bracket with the bolt.

    2. Install the air pre-cleaner to the cool air intake duct.

      Tip:

      Fit the air pre-cleaner into the groove of the cool air intake duct with the side stamped "FRONT" facing forward.

    3. A015A05E02

      Tighten the bolt of the inlet air cleaner bracket.

      Tip:

      When tightening bolt, make sure that the clearance labeled A in the illustration os as specified.

      Standard clearance
      0 to 5 mm (0 to 1.97 in.)