SNORKEL AIR CLEANER REMOVAL


  1. REMOVE AIR PRE-CLEANER ASSEMBLY


    1. A015BNK

      Remove the bolt, air pre-cleaner and No. 2 inlet air cleaner bracket.

  2. REMOVE COOL AIR INTAKE DUCT


    1. A0156JA

      Remove the 2 bolts and cool air intake duct.

  3. REMOVE COOL AIR INTAKE PIPE RETAINER


    1. A015E5G

      Remove the 2 bolts and cool air intake pipe retainer.

  4. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH


    1. Remove the 3 bolts and 2 screws.

    2. Loosen the clip and remove the front fender splash shield RH.

  5. REMOVE FRONT FENDER LINER RH


    1. Remove the screw and disconnect the liner from the front bumper cover.

    2. Using a T30 "TORX" socket, remove the 3 screws.

    3. Remove the 5 clips.

      Tech Tips

      It is not necessary to fully remove the fender liner. Partially remove it so that the air pump can be removed.

  6. REMOVE NO. 1 INLET AIR CLEANER


    1. A015A3E

      Remove the 2 bolts.

    2. Detach the claw shown in the illustration, and then remove the No. 1 inlet air cleaner.

  7. REMOVE AIR CLEANER ASSEMBLY


    1. Disconnect the mass air flow meter connector and using a clip remover, detach the wire harness clamp from the air cleaner cap.

    2. Using a clip remover, detach the wire harness clamp from the air cleaner case.

    3. Remove the 3 bolts and air cleaner case.

  8. REMOVE NO. 2 INLET AIR CLEANER


    1. A0158FT

      Remove the 2 bolts and inlet air cleaner.

  9. REMOVE INLET AIR CLEANER SEAL BRACKET SUB-ASSEMBLY


    1. A01573G

      Remove the 2 bolts and inlet air cleaner seal bracket.