REAR NO. 2 SEAT OUTER BELT ASSEMBLY REMOVAL

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.


  1. REMOVE REAR NO. 2 SEAT ASSEMBLY


    1. Remove the rear No. 2 seat assembly Click here.

  2. REMOVE REAR FLOOR MAT REAR SUPPORT PLATE

    A015BES

    1. Detach the 6 clips and remove the support plate.

  3. REMOVE REAR STEP COVER

    A0159DZ

    Tech Tips

    Use the same procedure to remove the step cover on the other side.


    1. Detach the 2 claws and remove the step cover.

  4. REMOVE REAR DOOR SCUFF PLATE LH

    A015BJQ

    1. Remove the screw.

    2. Detach the 3 claws and 4 clips, and remove the scuff plate.

  5. REMOVE REAR NO. 2 SEAT COVER BEZEL

    A0156BS

    1. Detach the 6 clips and remove the rear No. 2 seat cover bezel.

  6. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY LH

    A0157OV
    A0158A5

    Tech Tips

    When installing the front quarter trim panel, operate the reclining adjuster release handle and move the No. 1 rear seat to the position shown in the illustration.


    1. Detach the 3 claws and remove the cover.

    2. A015CT4

      Remove the bolt and disconnect the rear seat outer belt floor anchor.

    3. A0156NH

      for LH Side:


      1. Remove the bolt and disconnect the rear No. 2 seat outer belt floor anchor LH.

    4. A015DRR

      for RH Side:


      1. Detach the 3 claws and remove the cover.

      2. A015C42

        Remove the bolt and disconnect the rear seat outer belt floor anchor RH.

    5. Remove the clip and bolt.

    6. Detach the 18 clips and 2 claws.

      A0157GF

    7. w/o Rear Air Conditioning System:

      Disconnect the rear seat lock control lever cable and then remove the quarter trim panel.

    8. w/ Rear Air Conditioning System:

      Disconnect the thermistor connector and rear seat lock control lever cable, and then remove the quarter trim panel.

  7. REMOVE REAR NO. 2 SEAT OUTER BELT ASSEMBLY LH


    1. A015BNQE01

      Remove the bolt and disconnect the seat belt shoulder anchor.


      1. Using a screwdriver, detach the 2 claws and open the seat belt anchor cover as shown in the illustration.

        Tech Tips

        Tape the screwdriver tip before use.

      2. A015D6A

        Remove the bolt and seat belt shoulder anchor.

    2. A015AAG

      Remove the bolt and rear No. 2 seat outer belt.