LUMBAR SWITCH (for Manual Seat) REMOVAL

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.


  1. REMOVE FRONT SEAT ASSEMBLY LH


    1. Remove the front seat assembly Click here.

  2. REMOVE VERTICAL ADJUSTER COVER LH (for 8 Way Seat Type)

    A015C1M

    1. Using a screwdriver, detach the 2 claws and remove the vertical adjuster cover LH.

      Tech Tips

      Tape the screwdriver tip before use.

  3. REMOVE VERTICAL ADJUSTING HANDLE LH (for 8 Way Seat Type)

    A015DU7

    1. Remove the 2 screws and vertical adjusting handle LH.

  4. REMOVE VERTICAL SEAT ADJUSTER KNOB (for 8 Way Seat Type)

    A0159FT

    1. Remove the snap ring and vertical seat adjuster knob.

  5. REMOVE RECLINING ADJUSTER RELEASE HANDLE LH

    A0158UEE01

    1. Lift the reclining adjuster release handle LH.

    2. Using a screwdriver, detach the claw and remove the reclining adjuster release handle LH.

      Tech Tips

      Tape the screwdriver tip before use.

  6. REMOVE FRONT SEAT CUSHION SHIELD LH


    1. A015ANG

      w/ Seatback Board:

      Disconnect the 2 rubber bands from the 2 hooks.

    2. A015CXB

      w/o Seatback Board:

      Disconnect the rubber band from the 2 hooks.

    3. A0157H3E02

      for 4 Way Seat Type:


      1. Remove the 2 screws.

      2. Detach the 3 claws in the order shown in the illustration, and then remove the front seat cushion shield LH.

    4. A0159PPE01

      for 8 Way Seat Type:


      1. Remove the 3 screws.

      2. Detach the 3 claws in the order shown in the illustration, and then remove the front seat cushion shield LH.

    5. w/ Lumbar Support:

      Disconnect the lumbar switch connector.

  7. REMOVE LUMBAR SWITCH (w/ Lumbar Support)

    A015ABX

    1. Remove the 2 screws and switch.