REAR NO. 2 SEAT ASSEMBLY (except Face to Face Seat Type) INSTALLATION

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.


  1. INSTALL REAR SEAT LOCK STRIKER SUB-ASSEMBLY


    1. Install the 4 seat lock strikers with 8 bolts.

      Torque:
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }

    2. Return the floor carpet to its original position.

  2. INSTALL NO. 3 SEAT CUSHION COVER


    1. Attach the 16 claws and 4 clips to install the 4 seat cushion covers.

  3. INSTALL FOLD SEAT LEG LOCK SUB-ASSEMBLY


    1. Install the fold seat leg lock with the 2 nuts.

      Torque:
      12 N*m  { 122 kgf*cm, 9 ft.*lbf }

    2. Attach the 2 cable clamps.

  4. INSTALL REAR ROOF NO. 1 AIR DUCT (w/ Rear Air Conditioning System)

    A0159CK

    1. Install the duct with the clip.

    2. A0155T2

      Attach the 2 claws to install the cooler plate.

  5. INSTALL REAR SEAT LOCK CONTROL LEVER SUB-ASSEMBLY LH


    1. Attach the 4 claws to install the seat lock control lever.

  6. INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY LH


    1. w/ Sliding Roof:

      Install the front quarter trim panel assembly LH Click here.

    2. w/o Sliding Roof:

      Install the front quarter trim panel assembly LH Click here.

  7. INSTALL REAR SEAT COVER CAP

    A015E2E

    Tech Tips

    Use the same procedure to install the rear seat cover cap on the other side.


    1. Attach the 3 claws to install the rear seat cover cap.

  8. INSTALL REAR FLOOR MAT REAR SUPPORT PLATE

    A015BES

    1. Attach the 6 clips to install the support plate.

  9. INSTALL REAR DOOR SCUFF PLATE LH

    A015BJQ

    1. Attach the 3 claws and 4 clips to install the scuff plate.

    2. Install the screw.

  10. INSTALL REAR STEP COVER

    A0159DZ

    Tech Tips

    Use the same procedure to install the step cover on the other side.


    1. Attach the 2 claws to install the step cover.

  11. INSTALL REAR NO. 2 SEAT ASSEMBLY

    A0159NKE01

    1. Temporarily install the seat assembly with the 4 bolts.

      Note

      Be careful not to damage the vehicle body.

    2. Tighten the bolts in the order shown in the illustration.

      Torque:
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }

  12. INSTALL REAR NO. 2 SEAT HINGE COVER LH


    1. Attach the clip and 2 claws to install the cover.

  13. INSTALL REAR SEAT CUSHION HINGE COVER LH


    1. Attach the 3 claws to install the cover.

    2. Return the seat to the upright position.

  14. INSTALL REAR NO. 2 SEAT HEADREST ASSEMBLY LH (w/ Rear Center Seat Headrest)