REAR NO. 1 SEAT ASSEMBLY (for 60/40 Split Seat Type 40 Side) DISASSEMBLY

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.


  1. REMOVE SEAT ADJUSTER BOLT COVER

    A0159SB

    1. Using a screwdriver, detach the 2 claws and remove the cover.

      Tech Tips

      Tape the screwdriver tip before use.

  2. REMOVE RECLINING ADJUSTER RELEASE HANDLE RH

    A0157PZ

    1. Remove the screw and release handle.

  3. REMOVE REAR NO. 1 SEAT RECLINING COVER RH

    A0156G2E01

    1. Remove the 2 screws.

    2. Detach the 3 claws in the order shown in the illustration, and then remove the cover.

  4. REMOVE REAR NO. 1 SEAT RECLINING COVER LH

    A0155OK

    1. Remove the 2 screws.

    2. Detach the 4 claws and remove the cover.

  5. REMOVE UPPER SEAT TRACK RAIL COVER LH

    A015D8D

    1. Using a screwdriver, detach the 2 claws and remove the cover.

      Tech Tips

      Tape the screwdriver tip before use.

  6. REMOVE UPPER SEAT TRACK RAIL COVER RH

    A0156OW

    1. Using a screwdriver, detach the 2 claws and remove the cover.

      Tech Tips

      Tape the screwdriver tip before use.

  7. REMOVE NO. 1 SEAT CUSHION COVER

    A0158SE

    1. Detach the 4 claws and remove the 2 covers.

  8. REMOVE REAR NO. 2 SEAT LEG SIDE COVER


    1. A015A1T

      Remove the 4 screws and detach the 3 claws.

    2. A015A0P

      Remove the bolt that is securing the fold seat stopper band and remove the seat leg side cover together with the fold seat stopper band.

  9. REMOVE FOLD SEAT STOPPER BAND ASSEMBLY


    1. Remove the fold seat stopper band from the seat leg side cover.

  10. REMOVE REAR SEAT SIDE HINGE FEMALE COVER

    A015CYP

    1. Using a screwdriver, detach the 6 claws and remove the 2 covers.

      Tech Tips

      Tape the screwdriver tip before use.

  11. REMOVE REAR SEAT SIDE HINGE MALE COVER LH

    A0157HN

    1. Detach the clip and remove the cover.

  12. REMOVE REAR SEAT SIDE HINGE MALE COVER RH


    1. Detach the clip and remove the cover.

  13. REMOVE REAR NO. 2 SEAT PROTECTOR


    1. A0159RK

      w/ Rear Seat Side Airbag:

      Detach the claw and remove the wire harness connector.

    2. w/ Seat Heater System:

      Detach the claw and remove the wire harness connector.

    3. A0157OL

      Using a clip remover, remove the clip.

    4. Detach the claw and remove the seat protector from the seat hinge.

    5. Detach the 2 claws, open the protector and remove the wire harness.

  14. REMOVE REAR NO. 1 SEAT HINGE SUB-ASSEMBLY LH

    A0158E3

    1. Remove the 2 nuts and hinge.

  15. REMOVE REAR NO. 1 SEAT HINGE SUB-ASSEMBLY RH

    A0157CR

    1. w/ Rear Seat Side Airbag:

      Detach the wire harness clamp.

    2. w/ Seat Heater System:

      Detach the wire harness clamp.

    3. Remove the 2 nuts and hinge.

    4. A0155TF

      Detach the cable clamp and disconnect the cable.

  16. REMOVE REAR SEAT COVER


    1. A015B8U

      Detach the 12 claws.

    2. A015BSB

      Remove the 3 screws.

    3. Detach the 2 claws and remove the cover.

  17. REMOVE REAR UNDER SIDE COVER LH

    A0157GR

    1. Remove the 5 screws.

    2. Detach the clip and 2 claws, and remove the cover.

  18. REMOVE NO. 1 SEAT CUSHION PLATE

    A015B2F

    1. Detach the 3 claws and remove the seat cushion plate.

  19. REMOVE REAR SEAT UNDER TRAY COVER RH

    A01585Q

    1. Remove the 2 screws.

    2. Detach the 4 claws and remove the cover.

  20. REMOVE REAR SEAT TRACK HANDLE SUB-ASSEMBLY


    1. A0157IS

      Remove the 2 screws and seat track handle.

    2. A0159IZ

      Detach the 2 cable clamps and disconnect the 2 cables.

    3. A0157BR

      Detach the cable clamp and disconnect the cable.

  21. REMOVE FOLD SEAT LOCK CONTROL CABLE SUB-ASSEMBLY

  22. REMOVE SEAT CUSHION COVER WITH PAD


    1. w/ Rear Seat Side Airbag:


      1. Detach the side airbag wire harness clamps.

      2. Remove the side airbag wire harness through the hole in the seat cushion.

    2. w/ Seat Heater System:


      1. A0158YQ

        Disconnect the 2 seat heater connectors.

      2. A0157EF

        Remove the seatback heater wire harness through the hole in the seat cushion.

    3. Remove the seat cushion cover with pad.

  23. REMOVE REAR SEPARATE TYPE SEAT CUSHION COVER


    1. A015E1OE01

      Detach the 3 pieces of fastening tape.

    2. A015D38

      Remove the hog rings and cover.

  24. REMOVE REAR SEAT CUSHION HEATER ASSEMBLY (w/ Seat Heater System)

    A0157GG

    1. Cut off the tack pins which fasten the seat heater to the seat cushion cover, and then remove the seat cushion heater from the seat cushion cover.

  25. REMOVE REAR SEATBACK COVER

    A015D4NE01

    1. Using a screwdriver, detach the 4 claws and remove the cover.

      Tech Tips

      Tape the screwdriver tip before use.

  26. REMOVE REAR SEATBACK BOARD SUB-ASSEMBLY RH

    A01595A

    1. Detach the 2 claws on the top of the board.

    2. Pull up the board to detach the 2 claws on the bottom of the board and remove it.

  27. REMOVE REAR SEAT HEADREST ASSEMBLY

  28. REMOVE REAR NO. 1 SEAT HEADREST SUPPORT ASSEMBLY

    A015C63

    1. Detach the 4 claws and remove the 2 supports.

  29. REMOVE SEATBACK COVER WITH PAD


    1. A015BVA

      Remove the hog rings.

    2. A015DLA

      w/ Rear Seat Side Airbag:


      1. Remove the cap nut and seatback cover bracket from the seat frame.

      2. Remove the side airbag wire harness through the hole in the seatback.

    3. w/ Seat Heater System:


      1. A0157H9E01

        Cut the cable tie and disconnect the seatback heater wire harness.

      2. A015B81

        Remove the seatback heater wire harness through the hole in the seatback.

    4. Remove the seatback cover with pad.

  30. REMOVE REAR SEPARATE TYPE SEATBACK COVER


    1. A01596V

      w/ Rear Seat Side Airbag:

      Disconnect the seatback cover bracket from the seatback pad.

    2. A0155QP

      Remove the hog rings and rear seatback cover.

  31. REMOVE REAR SEATBACK HEATER ASSEMBLY (w/ Seat Heater System)

    A015E4H

    1. Cut off the tack pins which fasten the seatback heater to the seatback cover, and then remove the seatback heater from the seatback cover.

  32. REMOVE REAR SEAT RECLINING COVER LH

    A015AOA

    1. Remove the screw.

    2. Detach the claw and remove the cover.

  33. REMOVE REAR SEAT RECLINING COVER RH


    1. Remove the screw.

    2. Detach the claw and remove the cover.

  34. REMOVE REAR NO. 2 SEAT RECLINING COVER LH

    A015DO8

    1. Remove the screw.

    2. Detach the clamp and remove the cover.

  35. REMOVE REAR NO. 1 SEAT RECLINING COVER RH

    A015CWN

    1. Remove the screw.

    2. Detach the claw and remove the cover.

  36. REMOVE RECLINING ADJUSTING CABLE ASSEMBLY RH

    A015CJN

    1. Detach the 2 cable clamps and disconnect the cable.

    2. Detach the clamp and remove the adjusting cable.

  37. REMOVE NO. 1 FOLD SEAT LOCK CONTROL CABLE ASSEMBLY

    A015E71

    1. Detach the 2 cable clamps and disconnect the cable.

    2. Detach the clamp and remove the lock control cable.

  38. REMOVE REAR SEATBACK FRAME SUB-ASSEMBLY RH

    A0159FP

    1. Using a T40 "TORX" socket, remove the 4 bolts.

    2. Remove the seatback frame.

  39. REMOVE FOLD SEAT LOCK CONTROL CABLE SUB-ASSEMBLY

    A0158VC

    1. Detach the 2 cable clamps and disconnect the 2 cables.

    2. Remove the 2 fold seat lock control cables.

  40. REMOVE REAR NO. 1 SEAT LOCK CABLE ASSEMBLY


    1. A01577Q

      Remove the 2 nuts and lower seat track bracket.

    2. A0159L8

      Remove the 2 nuts and lower seat track bracket.

    3. A0157VK

      Detach the 3 cable clamps and disconnect the 3 cables.

    4. Detach the clamp and remove the seat lock cable.

  41. REMOVE REAR SEAT CUSHION HOLDER BRACKET RH (w/ Seat Heater System)

    A0158EN

    1. Disconnect the seat wire connector.

    2. Remove the 2 screws and holder bracket.

  42. REMOVE SEAT HEATER CONTROL SUB-ASSEMBLY RH (w/ Seat Heater System)

    A0157XZ

    1. Detach the 2 claws and remove the seat heater control.

  43. REMOVE REAR NO. 1 SEAT INNER BELT ASSEMBLY RH

    A015DNZE01

    1. Remove the bolt and belt.

  44. REMOVE REAR SEAT CUSHION FRAME SUB-ASSEMBLY RH

    A015AC9

    1. Using a T40 "TORX" socket, remove the bolt.

    2. Remove the 5 nuts and seat cushion frame.

  45. REMOVE REAR NO. 1 SEAT LOCK CONTROL LEVER

    A015BAO

    1. Remove the bolt and lock control lever.