DESCRIPTION
This DTC is stored when a malfunction in the stop light operation relay circuit of the vehicle stability control system is detected. This circuit consists of the master cylinder solenoid (skid control ECU) and seat belt control ECU. Signals are sent from the master cylinder solenoid (skid control ECU) via the CAN communication line.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| B2071 | Malfunction in the brake system is detected. |
|
INSPECTION PROCEDURE
PROCEDURE
CHECK DTC (CAN COMMUNICATION SYSTEM)
Use the intelligent tester to check if the CAN communication system is functioning normally (Click herefor LHD,Click herefor RHD).
| Result | Proceed to |
|---|---|
| OK (DTC U0122 is not output) |
A |
| NG (for LHD) |
B |
| NG (for RHD) |
C |
DTC U0122: Lost Communication with Skid Control ECU
CHECK DTC (VEHICLE STABILITY CONTROL SYSTEM)
Using the intelligent tester, enter the following menus: Chassis / ABS/VSC/TRAC / Trouble Code.
Clear the DTCs (Click here).
Check for DTCs (Click here).
| OK |
|---|
| DTC C1380 is not output. |
DTC C1380: Stop Light Control Relay Malfunction
CHECK DTC (PRE-CRASH SAFETY SYSTEM)
Using the intelligent tester, enter the following menus: Body / Pre-Crash / Trouble Code.
Clear the DTCs (Click here).
Check for DTCs (Click here).
| Result | Proceed to |
|---|---|
| OK (DTC B2071 is not output) |
A |
| NG (for LHD) |
B |
| NG (for RHD) |
C |
USE SIMULATION METHOD TO CHECKClick here
GO TO CAN COMMUNICATION SYSTEMClick here
GO TO CAN COMMUNICATION SYSTEMClick here
GO TO VEHICLE STABILITY CONTROL SYSTEM (DTC C1380)Click here
REPLACE SEAT BELT CONTROL ECUClick here
REPLACE SEAT BELT CONTROL ECUClick here