PRE-CRASH SAFETY SYSTEM, Diagnostic DTC:B2060

DESCRIPTION

This DTC is stored when a malfunction in the vehicle stability control system is detected. This circuit consists of the master cylinder solenoid (skid control ECU) and seat belt control ECU. Signals are sent from the master cylinder solenoid (skid control ECU) via the CAN communication line.

WIRING DIAGRAM

INSPECTION PROCEDURE

PROCEDURE

1. CHECK DTC (CAN COMMUNICATION SYSTEM)

   
   

   1. Use the intelligent tester to check if the CAN communication system is functioning normally Click here for LHD, Click here for RHD).

      Result

      Result	Proceed to
      OK (DTC U0122 is not output)	A
      NG (for LHD)	B
      NG (for RHD)	C

      Tech Tips

      DTC U0122: Lost Communication with Skid Control ECU

   
   

   B

   GO TO CAN COMMUNICATION SYSTEM Click here

   C

   GO TO CAN COMMUNICATION SYSTEM Click here

   A

2. CHECK DTC (VEHICLE STABILITY CONTROL SYSTEM)

   
   

   1. Using the intelligent tester, enter the following menus: Chassis / ABS/VSC/TRAC / Trouble Code.

   2. Clear the DTCs Click here.

   3. Check for DTCs Click here.

      OK
      DTC is not output.

   
   

   NG

   GO TO VEHICLE STABILITY CONTROL SYSTEM (DTC CHART) Click here

   OK

3. CHECK DTC (PRE-CRASH SAFETY SYSTEM)

   
   

   1. Using the intelligent tester, enter the following menus: Body / Pre-Crash / Trouble Code.

   2. Clear the DTCs Click here.

   3. Check for DTCs Click here.

      Result

      Result	Proceed to
      OK (DTC B2060 is not output)	A
      NG (for LHD)	B
      NG (for RHD)	C

   
   

   B

   REPLACE SEAT BELT CONTROL ECU Click here

   C

   REPLACE SEAT BELT CONTROL ECU Click here

   A

   USE SIMULATION METHOD TO CHECK Click here