Click here

KNEE AIRBAG ASSEMBLY (for Front Passenger Side) REMOVAL

Click here
Click here Click here
Tip:

  • Use the same procedures for the RHD and LHD.

  • The procedures listed below are the LHD side.

Click here
  1. Click here

    DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  2. Click here

    REMOVE FRONT DOOR SCUFF PLATE RH

    Tip:

    Use the same procedures described for the LH side.

  3. Click here

    REMOVE NO. 1 INSTRUMENT PANEL FINISH CUSHION


    1. Put protective tape around the No. 1 instrument panel finish panel cushion.

      Table 1. Text in Illustration
      *1 Protective Tape

    2. Using a moulding remover, detach the 7 claws and remove the No. 1 instrument panel finish panel cushion.

  4. Click here

    REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH


    1. Remove the clip and screw.

    2. Detach the 7 claws and remove the lower instrument panel pad sub-assembly.

  5. Click here

    REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Floor Under Cover)


    1. Detach the 4 claws and remove the No. 2 instrument panel under cover.

  6. Click here

    REMOVE FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY


    1. A01598PE01

      Remove the 4 bolts.

    2. Detach the 4 claws and remove the front passenger side knee airbag.

    3. Disconnect the connector.

      Note:

      When handling the airbag connector, take care not to damage the airbag wire harness.