Click here

SPIRAL CABLE REMOVAL

Click here
Click here Click here
  1. Click here

    DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  2. Click here

    PLACE FRONT WHEELS FACING STRAIGHT AHEAD

  3. Click here

    REMOVE LOWER NO. 3 STEERING WHEEL COVER


    1. A015BV6

      Detach the 2 claws and remove the steering wheel cover.

  4. Click here

    REMOVE LOWER NO. 2 STEERING WHEEL COVER


    1. A0159MPE01

      Detach the 2 claws and remove the steering wheel cover.

  5. Click here

    REMOVE STEERING PAD


    1. A0158E8E01

      Using a T30 "TORX" socket wrench, loosen the 2 screws until the groove along the screw circumference catches on the screw case.

    2. A0155SD

      Pull out the steering pad from the steering wheel, as shown in the illustration. Then support the steering pad with one hand.

      Note:

      When removing the steering pad, do not pull the airbag wire harness.

    3. Disconnect the horn connector.

    4. Disconnect the 2 connectors and remove the steering pad.

      Note:

      When handling the airbag connector, take care not to damage the airbag wire harness.

  6. Click here

    REMOVE STEERING WHEEL ASSEMBLY


    1. Remove the steering wheel set nut.

    2. A0155JKE03

      Put matchmarks on the steering wheel and main shaft.

      Table 1. Text in Illustration
      *a Matchmark
      *b Hold
      *c Turn

    3. Using SST, remove the steering wheel assembly.

      09950-50013 09951-05010 09952-05010 09953-05020 09954-05011
  7. Click here

    REMOVE LOWER STEERING COLUMN COVER


    1. A0158ZO

      Remove the 3 screws.

    2. Detach the 2 claws to remove the lower steering column cover.

      Note:

      Do not damage the tilt and telescopic switch.

  8. Click here

    REMOVE UPPER STEERING COLUMN COVER


    1. A015A4N

      Detach the 4 clips.

    2. Detach the claw to remove the upper steering column cover.

  9. Click here

    REMOVE SPIRAL CABLE


    1. A01588U

      Disconnect the connectors from the spiral cable with steering sensor.

      Note:

      When handling the airbag connector, take care not to damage the airbag wire harness.

    2. Detach the 3 claws and remove the spiral cable with steering sensor.

    3. A0158HRE03

      Detach the 6 claws and remove the spiral cable from the steering sensor.