COMPRESSOR (for 3UR-FE)

Click here

Click here Click here

Click here
REMOVE UPPER RADIATOR SUPPORT SEAL
1. Remove the 7 clips and radiator support seal.
Click here
RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
1. Start the engine.
2. Turn the A/C switch on.
3. Operate the cooler compressor while the engine speed is approximately 1000 rpm for 5 to 6 minutes to circulate the refrigerant and collect the compressor oil remaining in each component into the cooler compressor.
4. Stop the engine.
5. Recover the refrigerant from the A/C system using a refrigerant recovery unit.
Click here
REMOVE FRONT FENDER APRON SEAL LH
1. Remove the 4 clips and seal.
Click here
REMOVE FAN & GENERATOR V BELT
1. While turning the belt tensioner counterclockwise, align the service hole for the belt tensioner and the belt tensioner fixing position, and then insert a bar of 5 mm (0.197 in.) into the service hole to fix the belt tensioner in place.
  
  Table 1. Text in Illustration
  
  *1 Bar
  
  Tip:
  The pulley bolt for the belt tensioner has a left-hand thread.
2. Remove the V belt.
Click here
DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE
1. Remove the bolt and disconnect the discharge hose from the cooler compressor.
2. Remove the O-ring from the discharge hose.
  
  Note:
  Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.
Click here
DISCONNECT SUCTION HOSE SUB-ASSEMBLY
1. Remove the bolt and disconnect the suction hose from the cooler compressor.
2. Remove the O-ring from the suction hose.
  
  Note:
  Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.
Click here
REMOVE COOLER COMPRESSOR ASSEMBLY
1. Disconnect the connector.
2. Remove the 3 bolts and nut.
3. Remove the stud bolt and cooler compressor.

COMPRESSOR (for 3UR-FE) REMOVAL