Click here

SFI SYSTEM, Diagnostic DTC:P0657

Click here
Click here Click here
DTC Code DTC Name
P0657 Actuator Supply Voltage Circuit / Open
Click here

DESCRIPTION

The ECM monitors the output voltage to the throttle actuator. This self-check ensures that the ECM is functioning properly. The output voltage usually is 0 V when the engine switch is turned off. If the output voltage is higher than 7 V when the engine switch is turned off, the ECM will illuminate the MIL and store DTC(s) when the engine switch is turned on (IG).

DTC Code DTC Detection Condition Trouble Area
P0657 A throttle actuator power supply error. ECM
Click here

INSPECTION PROCEDURE

Click here

PROCEDURE


  1. Click here

    CHECK DTC


    1. Clear DTC (Click here).

    2. Turn the engine switch off.

    3. Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.

    4. Connect the cable to the negative (-) battery terminal.

    5. Turn the engine switch on (IG) for 10 seconds.

    6. Turn the engine switch off.

    7. Turn the engine switch on (IG).

    8. Check DTC.

      OK
      P0657 is not output.

  2. Click here

    CHECK FOR INTERMITTENT PROBLEMSClick here

  3. Click here

    REPLACE ECMClick here