Click here

SFI SYSTEM, Diagnostic DTC:P060A

Click here
Click here Click here
DTC Code DTC Name
P060A Internal Control Module Monitoring Processor Performance
Click here

DESCRIPTION

The main CPU and sub CPU of the ECM perform data communication between each other. The main CPU monitors the communications and WDC pulses from the sub CPU. When the signal malfunctions below are detected, a DTC is stored.

DTC Code DTC Detection Condition Trouble Area
P060A

When one of the following conditions is met:


  • An ECM main CPU error.

  • An ECM sub CPU error.

  • An electronic throttle monitoring CPU error.

 ECM
Click here

INSPECTION PROCEDURE

Click here

PROCEDURE


  1. Click here

    CHECK DTC


    1. Clear DTC (Click here).

    2. Turn the engine switch off.

    3. Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.

    4. Connect the cable to the negative (-) battery terminal.

    5. Turn the engine switch on (IG).

    6. Check DTC.

      OK
      P060A is not output.

  2. Click here

    CHECK FOR INTERMITTENT PROBLEMSClick here

  3. Click here

    REPLACE ECMClick here