Click here

ENGINE COOLANT TEMPERATURE SENSOR INSPECTION

Click here
Click here Click here
  1. Click here

    INSPECT ENGINE COOLANT TEMPERATURE SENSOR


    1. Partially immerse the sensor in water and warm up the water.

    2. Measure the resistance according to the value(s) in the table below.

      Standard resistance
      Tester Connection Condition Specified Condition
      1 - 2 Approximately 20°C (68°F) 2.32 to 2.59 kΩ
      1 - 2 Approximately 80°C (176°F) 0.310 to 0.326 kΩ

      If the result is not as specified, replace the sensor.

      Tip:

      If the result is as specified, it is not necessary to replace the sensor.

      Note:

      When checking the sensor in water, keep the terminals dry. After the check, wipe the sensor dry.