ENGINE COOLANT TEMPERATURE SENSOR REMOVAL

REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH

1. 

   Remove the 3 bolts and screw.

2. Turn the clip indicated by the arrow in the illustration to remove the front fender splash shield sub-assembly LH.

REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

1. 

   Remove the 3 bolts and 2 screws.

2. Turn the clip indicated by the arrow in the illustration to remove the front fender splash shield sub-assembly RH.

REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

1. 

   Remove the 10 bolts and No. 1 engine under cover sub-assembly.

DRAIN ENGINE COOLANT

1. Loosen the radiator drain cock plug.

2. Remove the radiator cap and drain the coolant.

   Tip:

   Collect the coolant in a container and dispose of it according to the regulations in your area.

3. Loosen the 2 cylinder block drain cock plugs and drain the coolant from the engine.

4. Tighten the 2 cylinder block drain cock plugs.

   13 N*m

   130 kgf*cm

   9 ft.*lbf

5. 

   Tighten the radiator drain cock plug by hand.

   Table 1. Text in Illustration

   *1	Reservoir Cap	*2	Radiator Cap
   *3	Radiator Drain Cock Plug	*4	Cylinder Block Drain Cock Plug

REMOVE V-BANK COVER SUB-ASSEMBLY

1. 

   Raise the front of the V-bank cover to detach the 3 pins. Then remove the 2 V-bank cover hooks from the bracket, and remove the V-bank cover.

   Table 2. Text in Illustration

   *1	Grommet
   *2	Pin
   *3	Hook
   *4	Bracket