SFI SYSTEM, Diagnostic DTC:P060E

DTC Code DTC Name
P060E Internal Control Module Throttle Position Performance

DESCRIPTION

The ECM monitors the input signals of the throttle position sensor No. 1 and stop light switch. As the ECM monitors the input signals of the throttle position sensor No. 1 and the STP signals of the stop light switch, if the input signals and control signals deviate, a DTC is stored.

DTC No. DTC Detection Condition Trouble Area
P060E

Either condition is met (1 trip detection logic):


  • There is an ECM main CPU error.

  • There is an ECM sub CPU error.

 ECM

CONFIRMATION DRIVING PATTERN


  1. Turn the engine switch off.

  2. Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.

  3. Connect the cable to the negative (-) battery terminal.

  4. Turn the engine switch on (IG) and wait for 16 seconds or more.

INSPECTION PROCEDURE

PROCEDURE


  1. CHECK FOR DTC


    1. Connect the GTS to the DLC3.

    2. Turn the engine switch on (IG).

    3. Turn the GTS on.

    4. Clear DTCs Click here.

    5. Turn the GTS off.

    6. Turn the engine switch off.

    7. Disconnect the GTS.

    8. Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.

    9. Connect the cable to the negative (-) battery terminal.

    10. Connect the GTS to the DLC3.

    11. Turn the engine switch on (IG) and turn the GTS on.

    12. Wait 16 seconds or more.

    13. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

    14. Check for DTCs.

      OK
      P060E is not output.

    NG

    REPLACE ECM Click here

    OK

    CHECK FOR INTERMITTENT PROBLEMS Click here