THROTTLE BODY REMOVAL


  1. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH


    1. A01588F

      Remove the 3 bolts and screw.

    2. Turn the clip indicated by the arrow in the illustration to remove the front fender splash shield sub-assembly LH.

  2. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH


    1. A0159SG

      Remove the 3 bolts and 2 screws.

    2. Turn the clip indicated by the arrow in the illustration to remove the front fender splash shield sub-assembly RH.

  3. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY


    1. A0157XJ

      Remove the 10 bolts and No. 1 engine under cover.

  4. DRAIN ENGINE COOLANT

    CAUTION:

    Do not remove the radiator cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

    A01554XE01
    Text in Illustration
    *1 Radiator Reservoir *2 Radiator Cap
    *3 Radiator Drain Cock Plug *4 Cylinder Block Water Drain Cock Plug
    *a for Type A *b for Type B

    1. for Type A:

      Loosen the radiator drain cock plug and 2 cylinder block water drain cock plugs.

    2. for Type B:

      Loosen the radiator drain cock plug and cylinder block water drain cock plug.

    3. Remove the radiator cap. Then drain the coolant.

      Tech Tips

      Collect the coolant in a container and dispose of it according to the regulations in your area.

    4. for Type A:

      Tighten the 2 cylinder block water drain cock plugs.

      Torque:
      13 N*m  { 130 kgf*cm, 9 ft.*lbf }

    5. for Type B:

      Tighten the cylinder block water drain cock plug.

      Torque:
      13 N*m  { 130 kgf*cm, 9 ft.*lbf }

    6. Tighten the radiator drain cock plug by hand.

  5. REMOVE V-BANK COVER


    1. A0159TNE01
      Text in Illustration
      *1 Pin
      *2 Hook

      Raise the front of the V-bank cover to detach the 2 pins. Then remove the 2 V-bank cover hooks from the bracket, and remove the V-bank cover.

  6. REMOVE NO. 1 AIR CLEANER HOSE


    1. A01569C

      Disconnect the No. 2 PCV hose and vacuum hose.

    2. Remove the bolt and loosen the 2 hose clamps.

    3. Remove the No. 1 air cleaner hose.

  7. REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY


    1. A015DN8E01

      Disconnect the No. 5 water by-pass hose.

    2. A0159MUE01

      Disconnect the No. 4 water by-pass hose.

    3. A015ASPE01

      Disconnect the throttle position sensor and throttle control motor connector.

    4. Remove the 4 bolts, the throttle body with motor, and the gasket.