Click here

SFI SYSTEM, Diagnostic DTC:P060A

Click here
Click here Click here
DTC Code DTC Name
P060A Internal Control Module Monitoring Processor Performance
Click here

DESCRIPTION

The main CPU and sub CPU of the ECM perform data communication between each other. The main CPU monitors the communications and WDC pulses from the sub CPU. When the signal malfunctions below are detected, this DTC is stored.

DTC No. DTC Detection Condition Trouble Area
P060A There is an ECM sub CPU error (1 trip detection logic). ECM
Click here

INSPECTION PROCEDURE

Click here

PROCEDURE


  1. Click here

    CHECK FOR DTC


    1. Clear the DTCs (Click here).

    2. Turn the ignition switch off.

    3. Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.

    4. Connect the cable to the negative (-) battery terminal.

    5. Turn the ignition switch to ON.

    6. Check for DTCs.

      OK
      P060A is not output.

  2. Click here

    CHECK FOR INTERMITTENT PROBLEMSClick here

  3. Click here

    REPLACE ECMClick here