Click here

FUEL SENDER GAUGE ASSEMBLY (for Fuel Sub Tank) REMOVAL

Click here
Click here Click here
  1. Click here

    PRECAUTION

    Note:

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).

  2. Click here

    DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  3. Click here

    REMOVE REAR NO. 1 SEAT ASSEMBLY RH (for 60/40 Split Seat Type 40 Side)

    (Click here)

  4. Click here

    REMOVE REAR NO. 1 SEAT ASSEMBLY LH (for 60/40 Split Seat Type 60 Side)

    (Click here)

  5. Click here

    REMOVE REAR NO. 2 SEAT ASSEMBLY


    1. for Face to Face Seat Type:

      Remove the rear No. 2 seat assembly (Click here).

    2. except Face to Face Seat Type:

      Remove the rear No. 2 seat assembly (Click here).

  6. Click here

    REMOVE REAR FLOOR MAT ASSEMBLY


    1. Detach the 5 clips and fold back the floor mat toward the front of the vehicle.

      Tip:

      Fold back the floor mat so that the rear No. 7 air duct can be removed.

  7. Click here

    REMOVE REAR NO. 7 AIR DUCT


    1. A0158O5

      Detach the 4 clips and remove the air duct.

  8. Click here

    REMOVE REAR FLOOR SERVICE HOLE COVER

  9. Click here

    REMOVE FUEL SENDER GAUGE ASSEMBLY


    1. A015ACB

      Disconnect the sender gauge connector.

    2. Remove the 5 screws and sender gauge.

      Note:

      Be careful not to bend the arm of the fuel sender gauge.

    3. Remove the gasket from the sender gauge.