REAR CRANKSHAFT OIL SEAL REMOVAL


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY

    Click here

  4. REMOVE MANUAL TRANSMISSION UNIT ASSEMBLY

    Click here

  5. REMOVE CLUTCH COVER ASSEMBLY (for Manual Transmission)

    A015DXQE01

    1. Put matchmarks on the clutch cover and flywheel.

    2. Loosen each set bolt one turn at a time until spring tension is released.

    3. Remove the 8 set bolts, and pull off the clutch cover.

      Note

      Do not drop the clutch disc.

  6. REMOVE CLUTCH DISC ASSEMBLY (for Manual Transmission)

    Note

    Keep the lining part of the clutch disc, pressure plate and surface of the flywheel away from oil and foreign matter.

  7. REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY (for Automatic Transmission)


    1. A015782

      Using a wrench, hold the crankshaft.

      Note

      Do not turn the crankshaft counterclockwise.

      If it is turned counterclockwise, check that the crankshaft pulley set bolt is not loose. If loose, tighten the bolt Click here.

      Torque:
      108 N*m  { 1101 kgf*cm, 80 ft.*lbf, or more }
    2. A0157I7

      Remove the 8 bolts.

    3. A0158N2E01

      Remove the rear drive plate spacer labeled A, drive plate and ring gear labeled B and rear crankshaft balancer weight labeled C.

  8. REMOVE FLYWHEEL SUB-ASSEMBLY (for Manual Transmission)


    1. A015782

      Using a wrench, hold the crankshaft.

      Note

      Do not turn the crankshaft counterclockwise.

      If it is turned counterclockwise, check that the crankshaft pulley set bolt is not loose. If loose, tighten the bolt Click here.

      Torque:
      108 N*m  { 1101 kgf*cm, 80 ft.*lbf, or more }
    2. A0155ES

      Remove the 8 bolts and flywheel.

  9. REMOVE REAR CRANKSHAFT OIL SEAL


    1. A0156W9E02
      Text in Illustration
      *1 Cut Position
      *2 Oil Seal

      Using a knife, cut off the lip of the oil seal.

    2. Using a screwdriver, pry out the oil seal.

      Note

      Be careful not to damage the crankshaft.

      Tech Tips

      Tape the screwdriver tip before use.