FRONT CRANKSHAFT OIL SEAL INSTALLATION


  1. INSTALL FRONT CRANKSHAFT OIL SEAL


    1. Apply engine oil to the lip of a new oil seal.

    2. A015AUZE02

      Using SST and a hammer, tap in the oil seal as shown in the illustration.

      SST
      09316-12010
      09950-70010   ( 09951-07100 )
      09950-60020   ( 09951-00890 )
      Standard depth A
      0.6 to 1.4 mm (0.0236 to 0.0551 in.)

      Note

      Make sure that the lip of the oil seal is properly installed.

  2. INSTALL CRANKSHAFT PULLEY SUB-ASSEMBLY

    Note

    This procedure is intended for removal/installation of the crankshaft pulley only. Do not use this procedure for removal/installation of the flywheel or the drive plate and ring gear.


    1. A015DNAE02
      Text in Illustration
      *1 Service Hole
      *2 Protrusion

      Align the crankshaft pulley and the crankshaft knock pin, and temporarily install the crankshaft pulley with the 3 bolts.

    2. Install the 2 bolts to the bolt holes of the crankshaft rear side.

    3. Using a bar, turn the crankshaft until the crankshaft pulley service hole is a little to the right of bottom dead center.

    4. Install a 14 mm x 1.5 pitch service bolt with a length of 70 mm or more to the crankshaft pulley service hole, and hold the crankshaft using the timing chain cover protrusion.

    5. A015CV2E01

      Uniformly tighten the 3 bolts in 2 passes in the order shown in the illustration.

      Torque:
      115 N*m  { 1168 kgf*cm, 84 ft.*lbf }

    6. Remove the service bolt.

  3. INSTALL RADIATOR ASSEMBLY

    Click here