DRIVE BELT REMOVAL


  1. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH


    1. A015DL0

      Remove the 3 bolts and screw.

    2. Loosen the clip and remove the front fender splash shield LH.

  2. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH


    1. Remove the 3 bolts and 2 screws.

    2. Loosen the clip and remove the front fender splash shield RH.

  3. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY


    1. A0157XJ

      Remove the 10 bolts and No. 1 engine under cover.

  4. REMOVE UPPER RADIATOR SUPPORT SEAL


    1. Remove the 7 clips and upper radiator support seal.

  5. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY (w/ Intercooler)


    1. A015BEI

      Remove the 2 nuts and No. 1 engine cover.

  6. REMOVE AIR CLEANER CAP SUB-ASSEMBLY


    1. A0159QI

      Loosen the hose clamp.

    2. Disconnect the mass air flow meter connector and using a clip remover, detach the wire harness clamp from the air cleaner cap.

    3. Detach the 4 clamps and remove the air cleaner cap.

  7. REMOVE NO. 1 AIR CLEANER HOSE


    1. A015DGT

      Loosen the hose clamp and remove the No. 1 air cleaner hose.

  8. REMOVE INTAKE AIR CONNECTOR


    1. A015852E04
      Text in Illustration
      *A w/ Viscous Heater

      w/ Viscous Heater:

      Disconnect the 2 connectors from the viscous with magnet clutch heater and water temperature sensor.

    2. w/o Viscous Heater:

      Disconnect the connector from the water temperature sensor.

    3. Using a clip remover, detach the 3 wire harness clamps.

    4. A015DJJ

      Loosen the 2 hose clamps and remove the 2 bolts and intake air connector.

  9. REMOVE V-RIBBED BELT (w/ Viscous Heater)


    1. A0155TJ

      Loosen the lock nut and turn the bolt counterclockwise.

    2. Remove the V-ribbed belt.

  10. REMOVE NO. 1 IDLER PULLEY (w/ Viscous Heater)


    1. A015A7A

      Remove the bolt, cover, No. 1 idler pulley and collar.

  11. REMOVE NO. 3 IDLER PULLEY (w/ Viscous Heater)


    1. A015C7J

      Remove the nut and No. 3 idler pulley.

  12. REMOVE V-RIBBED BELT


    1. A015CL0

      Using a wrench to the V-ribbed belt tensioner bracket, turn the wrench clockwise and remove the V-ribbed belt.