DRIVE BELT INSTALLATION


  1. INSTALL FAN AND GENERATOR V BELT


    1. A015BDAE05
      Text in Illustration
      *1 Vane Pump
      *2 Water Pump
      *3 No. 1 Idler
      *4 Fan
      *5 Generator
      *6 Belt Tensioner
      *7 Crankshaft
      *8 Cooler Compressor

      Set the V belt onto every part.

    2. While turning the belt tensioner counterclockwise, remove the bar.

      Note

      Make sure that the V belt is properly set to each pulley.

    3. A0156XEE14
      Text in Illustration
      *a CORRECT
      *b INCORRECT

      After installing the belt, check that it fits properly in the ribbed grooves.

      Tech Tips

      Make sure to check by hand that the belt has not slipped out of the grooves on the bottom of the pulley.

  2. INSTALL V-BANK COVER SUB-ASSEMBLY


    1. A0157E7E02
      Text in Illustration
      *1 Bracket
      *2 Hook
      *3 Pin
      *4 Grommet

      Attach the 2 V-bank cover hooks to the bracket. Then align the 3 V-bank cover grommets with the 3 pins, and press down on the V-bank cover to attach the pins.

  3. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY


    1. Install the No. 1 engine under cover with the 10 bolts.

      Torque:
      29 N*m  { 296 kgf*cm, 21 ft.*lbf }

  4. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH


    1. Push in the clip to install the front fender splash shield sub-assembly LH.

    2. Install the 3 bolts and screw.

  5. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH


    1. Push in the clip to install the front fender splash shield sub-assembly RH.

    2. Install the 3 bolts and 2 screws.