REAR CRANKSHAFT OIL SEAL INSTALLATION


  1. INSTALL REAR CRANKSHAFT OIL SEAL


    1. Apply MP grease to the lip of a new oil seal.

    2. A0157EDE01

      Using SST and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.

      SST
      09223-56010

      Note


      • Keep the lip free from foreign matter.

      • Do not tap on the oil seal at an angle.

  2. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY


    1. A015A8OE03

      Using SST, hold the crankshaft.

      SST
      09213-70011
      09330-00021
    2. A015B5W

      Install the crankshaft angle sensor rotor.

      Text in Illustration
      A015DIT Engine Side

      Tech Tips


      • Align the pin hole of the crankshaft angle sensor rotor with the pin of the crankshaft.

      • As the crankshaft angle sensor rotor is not reversible, be sure to install it so that it is facing in the direction shown in the illustration.

    3. A0159FVE01
      Text in Illustration
      *1 Drive Plate
      *2 Rear Drive Plate Spacer
      A015DIT Automatic Transmission Side

      Install the drive plate and rear drive plate spacer onto the crankshaft.

      Tech Tips

      As the rear drive plate spacer and the drive plate are not reversible, be sure to install them so that they are facing in the direction shown in the illustration.

    4. Install the drive plate and ring gear and bolts.

      Tech Tips

      The bolts are tightened in 2 progressive steps.


      1. Clean the bolts and bolt holes.

      2. A01595GE03
        Text in Illustration
        *1 Adhesive

        Apply adhesive to 2 or 3 threads at the end of each of the 10 bolts.

        Adhesive
        Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
      3. A0155RDE01

        Step 1:

        Install and uniformly tighten 10 new bolts in the sequence shown in the illustration.

        Torque:
        30 N*m  { 301 kgf*cm, 22 ft.*lbf }

        Note


        • Do not reuse the drive plate installation bolts.

        • Do not strike or damage the drive plate installation bolts. Be sure to handle them carefully.

      4. Mark the upside of each drive plate installation bolt with paint.

      5. Step 2:

        Tighten the cylinder head bolts another 90°.

      6. Check that the painted marks are now at a 90° angle to the upside.

        Note

        Do not start the engine for at least an hour after installing the drive plate.

  3. INSTALL AUTOMATIC TRANSMISSION ASSEMBLY

    Click here

  4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.