Click here

REAR CRANKSHAFT OIL SEAL REMOVAL

Click here
Click here Click here
  1. Click here

    REMOVE AUTOMATIC TRANSMISSION ASSEMBLY (for Automatic Transmission)

    (Click here)

  2. Click here

    REMOVE MANUAL TRANSMISSION ASSEMBLY (for Manual Transmission)

    (Click here)

  3. Click here

    REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY (for Automatic Transmission)


    1. A015BDZE01

      Using SST, hold the crankshaft.

      09213-54015 91651-60855
      09330-00021
    2. A0157VC

      Remove the 8 bolts, rear spacer, drive plate and front spacer.

      Note:

      Do not reuse the bolts.

  4. Click here

    REMOVE CLUTCH COVER ASSEMBLY (for Manual Transmission)


    1. Put matchmarks on the clutch cover and flywheel.

    2. Loosen each set bolt one turn at a time until spring tension is released.

    3. Remove the 6 set bolts, and pull off the clutch cover.

      Note:

      Do not drop the clutch disc.

  5. Click here

    REMOVE CLUTCH DISC ASSEMBLY (for Manual Transmission)

    Note:

    Keep the lining part of the clutch disc, pressure plate and surface of the flywheel away from oil and foreign matter.

  6. Click here

    REMOVE FLYWHEEL SUB-ASSEMBLY (for Manual Transmission)


    1. A015BDZE01

      Using SST, hold the crankshaft.

      09213-54015 91651-60855
      09330-00021
    2. A015CX6

      Remove the 8 bolts and flywheel.

      Note:

      Do not reuse the bolts.

  7. Click here

    REMOVE REAR CRANKSHAFT OIL SEAL


    1. A01570PE03

      Using a knife, cut off the lip of the oil seal.

      Table 1. Text in Illustration
      *1 Cut Position

    2. Using a screwdriver, pry out the oil seal.

      Note:

      Do not damage the surface of the oil seal press fit hole or crankshaft.

      Tip:

      Tape the screwdriver tip before use.