Click here

ENGINE COOLANT TEMPERATURE SENSOR REMOVAL

Click here
Click here Click here
  1. Click here

    REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH


    1. Remove the 3 bolts and 2 screws.

    2. Loosen the clip and remove the front fender splash shield RH.

  2. Click here

    REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH


    1. A015DL0

      Remove the 3 bolts and screw.

    2. Loosen the clip and remove the front fender splash shield LH.

  3. Click here

    REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY


    1. A0157XJ

      Remove the 10 bolts and No. 1 engine under cover.

  4. Click here

    DRAIN ENGINE COOLANT

    CAUTION:

    Do not remove the radiator reservoir cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

    Tip:

    Collect the coolant in a container and dispose of it according to the regulations in your area.


    1. Loosen the radiator drain cock plug.

    2. Remove the radiator reservoir cap to drain the coolant in the radiator.

    3. A015DKUE01

      Loosen the oil filter bracket drain cock plug to drain the coolant in the engine.

    4. Tighten the radiator drain cock plug by hand.

    5. A0158UW

      Tighten the oil filter bracket drain cock plug.

      13 N*m 133 kgf*cm 10 ft.*lbf
  5. Click here

    REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY (w/ Intercooler)


    1. A015BEI

      Install the engine cover with the 2 nuts.

      8.0 N*m 82 kgf*cm 71 in.*lbf
  6. Click here

    REMOVE ENGINE COOLANT TEMPERATURE SENSOR


    1. Disconnect the sensor connector.

    2. Using a 19 mm deep socket wrench, remove the sensor and gasket.