FRONT BUMPER REMOVAL


  1. REMOVE COOL AIR INTAKE DUCT SEAL


    1. A01G7XF

      Remove the 9 clips and cool air intake duct seal.

  2. REMOVE HOOD CENTER CUSHION


    1. A01G70K

      Remove the 2 hood center cushions.

  3. REMOVE FRONT BUMPER ASSEMBLY


    1. A01G5T4E01
      Text in Illustration
      *1 Protective Tape

      Put protective tape around the front bumper assembly as shown in the illustration.

    2. A01G90NE01
      Text in Illustration
      *1 Pin Hold Clip

      Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    3. Remove the clip.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    4. A01G4J2E01
      Text in Illustration
      *1 Front Bumper Seal Bracket

      Remove the screw and front bumper seal bracket.

      Note

      Do not pull the front bumper assembly until the front bumper seal bracket is removed, or the front bumper assembly may be damaged.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    5. A01G74X

      Remove the 6 screws.

    6. A01G80U

      Disengage the 3 claws as shown in the illustration.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    7. A01G9JKE01

      Disengage the 2 claws as shown in the illustration.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    8. Pull back the side of the front bumper assembly and disconnect each connector.

      Note

      Do not apply excessive force when separating the front bumper.

    9. A01G58Q

      Using a clip remover, remove the 3 clips.

    10. w/ Headlight Cleaner System:


      1. A01G58Z

        Disconnect the headlight cleaner hose and drain the washer fluid.

        Tech Tips

        Use a container to collect the washer fluid.

    11. Remove the front bumper assembly.