AUTOMATIC HIGH BEAM MAIN SWITCH REMOVAL


  1. REMOVE LOWER CENTER INSTRUMENT PANEL FINISH PANEL


    1. A01G7SVE01
      Text in Illustration
      *a Lower Center Instrument Panel Finish Panel Hole

      Insert a moulding remover as shown in the illustration.

    2. A01G5J0

      Disengage the 2 claws and 5 clips and remove the lower center instrument panel finish panel as shown in the illustration.

  2. REMOVE FRONT DOOR SCUFF PLATE LH


    1. A01G8TA

      Disengage the 10 claws and remove the front door scuff plate LH.

  3. REMOVE COWL SIDE TRIM BOARD LH


    1. A01G75T

      Remove the clip.

    2. Disengage the claw and clip, and remove the cowl side trim board LH.

  4. REMOVE FRONT DOOR OPENING TRIM COVER LH


    1. A01G9KP

      Disengage the 3 claws.

    2. Disengage the guide and remove the front door opening trim cover LH.

  5. REMOVE INSTRUMENT SIDE PANEL LH


    1. A01G5PZ

      Using a moulding remover, disengage the 2 claws and 4 clips as shown in the illustration.

    2. A01G64E

      Disengage the 2 guides and remove the instrument side panel LH as shown in the illustration.

  6. DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    1. A01G4MG

      Disengage the claw and 2 guides to disconnect the hood lock control lever sub-assembly.

  7. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL


    1. A01G78A

      Remove the 2 bolts <B>.

    2. A01G4U5

      Disengage the 12 claws, 2 clips and guide.

    3. Disconnect each connector to remove the lower No. 1 instrument panel finish panel.

  8. REMOVE AUTO HIGH BEAM SWITCH


    1. A01G7MK

      Disengage the 2 claws and remove the auto high beam switch.