AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM HOW TO PROCEED WITH TROUBLESHOOTING

Tech Tips


  • Use the following procedure to troubleshoot the automatic headlight beam level control system.

  • *: Use the GTS.


  1. VEHICLE BROUGHT TO WORKSHOP


    NEXT

  2. CUSTOMER PROBLEM ANALYSIS AND SYMPTOM CHECK


    NEXT

  3. INSPECT BATTERY VOLTAGE


    1. Measure the battery voltage with the engine switch off.

      Standard Voltage
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.


      NEXT

  4. INSPECT CAN COMMUNICATION SYSTEM*


    1. Use the GTS to check if the CAN communication system is functioning normally.

      Result
      Result Proceed to
      CAN communication system DTCs are not output. A
      CAN communication system DTCs are output. B

      B

      GO TO CAN COMMUNICATION SYSTEM
      A

  5. CHECK FOR DTC*


    1. Check for DTCs Click here.

      Result
      Result Proceed to
      DTCs are not output. A
      DTCs are output. B

      B

      Go to step 8
      A

  6. PROBLEM SYMPTOMS TABLE


    1. Refer to Problem Symptoms Table Click here.

      Result
      Result Proceed to
      Fault is not listed in Problem Symptoms Table. A
      Fault is listed in Problem Symptoms Table. B

      B

      Go to step 8
      A

  7. OVERALL ANALYSIS AND TROUBLESHOOTING*


    1. Data List / Active Test Click here

    2. Terminals of ECU Click here


      NEXT

  8. ADJUST, REPAIR OR REPLACE


    NEXT

  9. CONFIRMATION TEST


    NEXT
    END