WIPER AND WASHER SYSTEM HOW TO PROCEED WITH TROUBLESHOOTING

Tech Tips

Use the following procedure to troubleshoot the wiper and washer system.


  1. VEHICLE BROUGHT TO WORKSHOP


    NEXT

  2. CUSTOMER PROBLEM ANALYSIS AND SYMPTOM CHECK


    NEXT

  3. INSPECT BATTERY VOLTAGE


    1. Measure the battery voltage with the engine switch off.

      Standard Voltage
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.


      NEXT

  4. PROBLEM SYMPTOMS TABLE

    Result
    Result Proceed to
    Fault is not listed in problem symptoms table A
    Fault is listed in problem symptoms table B

    B

    Go to step 6
    A

  5. OVERALL ANALYSIS AND TROUBLESHOOTING


    1. Terminals of ECU Click here

    2. Inspection

    3. On-vehicle inspection


      NEXT

  6. ADJUST, REPAIR OR REPLACE


    NEXT

  7. CONFIRMATION TEST


    NEXT
    END