OUTER REAR VIEW MIRROR GLASS REMOVAL

Tech Tips


  • Use the same procedure for both the RH and LH sides.

  • The procedure described below is for the LH side.


  1. REMOVE OUTER MIRROR


    1. Push the upper part of the mirror surface and tilt it.

    2. A01G7SSE01
      Text in Illustration
      *1 Protective Tape
      *2 Moulding Remover

      Apply protective tape to the areas shown in the illustration.

    3. Using a moulding remover, disengage the 2 claws at the lower part of the outer rear view mirror.

    4. Push the lower part of the mirror surface and tilt it.

    5. A01G83VE01
      Text in Illustration
      *1 Protective Tape
      *2 Moulding Remover

      Apply protective tape to the areas shown in the illustration.

    6. Using a moulding remover, disengage the 2 claws at the upper part of the outer rear view mirror.

    7. w/o Blind Spot Monitor System:


      1. A01G5VB

        Disengage the 2 clamps.

      2. Disconnect the 3 connectors and remove the outer mirror.

    8. w/ Blind Spot Monitor System:


      1. A01G87I

        Disengage the 3 clamps.

      2. Disconnect the 3 connectors and remove the outer mirror.

      3. Release the tabs of the blind spot monitor indicator connector to disconnect the connector and remove the outer mirror.

        Note


        • Do not bend the tabs excessively to prevent them from being damaged.

        • If the tabs are damaged, replace the outer mirror with a new one.