POWER MIRROR CONTROL SYSTEM (w/o Memory) TERMINALS OF ECU


  1. CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY


    1. Disconnect the H54 air conditioning amplifier assembly connector.

      A01G6ZQE11

    2. Measure the voltage and resistance according to the value(s) in the table below.

      Tech Tips

      Measure the values on the wire harness side with the connector disconnected.

      Tester Connection Wiring Color Terminal Description Condition Specified Condition
      H54-1 (IG+) - H54-14 (GND) V - W-B Power source (IG) Engine switch on (IG) 11 to 14 V
      H54-1 (IG+) - H54-14 (GND) V - W-B Power source (IG) Engine switch off Below 1 V
      H54-21 (B) - H54-14 (GND) GR - W-B ECU power supply Always 11 to 14 V
      H54-14 (GND) - Body ground W-B - Body ground Ground Always Below 1 Ω

      If the result is not as specified, there may be a malfunction in the wire harness.

    3. Reconnect the H54 air conditioning amplifier assembly connector.

    4. Measure the voltage according to the value(s) in the table below.

      Tester Connection Wiring Color Terminal Description Condition Specified Condition
      H54-38 (RDFG) - H54-14 (GND) G - W-B Mirror heater switch signal Engine switch on (IG), rear window defogger switch off 11 to 14 V
      H54-38 (RDFG) - H54-14 (GND) G - W-B Mirror heater switch signal Engine switch on (IG), rear window defogger switch on Below 2.2 V
      H54-37 (LIN1) - Body ground B - Body ground LIN communication signal Engine switch on (IG) Pulse generation

      If the result is not as specified, the air conditioning amplifier assembly may be malfunctioning.

  2. CHECK RADIO RECEIVER ASSEMBLY (w/o Multi-display) Click here

  3. CHECK MULTI-MEDIA MODULE RECEIVER ASSEMBLY (w/ Multi-display) Click here