WIPER AND WASHER SYSTEM IG Power Source Circuit

DESCRIPTION

This circuit provides power to the headlight cleaner control relay.

WIRING DIAGRAM

A01G5JIE01

INSPECTION PROCEDURE

Note

Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (HEADLIGHT CLEANER CONTROL RELAY - IG CIRCUIT AND BODY GROUND)


    1. Disconnect the A43 headlight cleaner control relay connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      A43-3 (IG) - Body ground Engine switch on (IG) 11 to 14 V

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      A43-4 (E) - Body ground Always Below 1 Ω

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here